ATD CAO-27228 Reverse Camera Input Cable For Nissan Audio Without Nav 32 Pin Connection

MAIN FEATURES

Audio Tech Direct now offers a range of cable adaptors to allow an after-market camera to be connected to the OEM factory radio. These are a great way of adding some much needed parking assistance to your factory radio. Please read the listing description carefully as coding and variants with the factory radio may apply.

This cable insert is an adapter harness for adding a reverse camera video input in various Nissan models (For a full model list please view Product Applications). This product connects inline at the back of the original head unit which then provides a 6v camera power outputs and an RCA video input. A reverse gear feed needs to be supplied to the adapter. Note: Some Vehicles may require programming to activate the reverse camera function they may also supply 6 volts to the camera not 12v so an additional power supply may have to be sourced in the vehicle.

This cable is for rear view camera connection in Nissan cars with OEM Nissan Audio multimedia system without navigation. Using this cable you will be able to install an aftermarket camera Plug & Play without damaging the car wires.

Image from the rear view camera will automatically be displayed on the screen when reversing. Dynamic parking lines that will turn with the steering wheel will be displayed on the camera image. Parking lines can be adjusted in the service menu (see parking lines adjustment manual). The device is connected to the 32 pin socket (as shown in the connection diagram). Depending on your car radio model, this socket may be located in a different place from the one shown in the diagram. After connection all OEM devices that work using this socket will not be disturbed and will continue to work as they did prior to the connection.

This 32 pin OEM camera adapter cable to allow you to add an aftermarket rear view camera to Nissan models with Nissan Audio multimedia systems (WITHOUT NAVIGATION). Upon installation, image from the aftermarket camera will automatically be displayed on the screen when reversing and parking lines can be adjusted in the service menu.

Features & Benefits:

• Power of the additionally installed rear view camera should be taken from the ACC line (first key turn) otherwise camera input will not be active
• Only supports NTSC cameras
• Compatible with Nissan models with Nissan Audio multimedia systems
• Depending on the car radio model, the 32 pin socket may be located in a different place from the one shown in the diagram below
• NTSC camera compatible only

VEHICLE COMPATIBILITY LIST

For models with Nissan Audio without navigation with 4.2", 5" or 7" colour screen.

Vehicle fitment (guide only):

• Nissan Cube (2011-2019)
• Nissan Frontier (2011-2019)
• Nissan Juke (2011-2019)
• Nissan Navara [D23] (2016-2019)
• Nissan NP300 [D23] (2016-2019)
• Nissan Micra (2011-2017)
• Nissan Note (2013-2018)
• Nissan NV200 (2010-2018)
• Nissan NV300 (2014-2018)
• Nissan Pulsar (2014-2018)
• Nissan Qashqai [J11] (2014-2017)
• Nissan X-Trail [T32] (2014-2017)

PLEASE NOTE:

1. If your car radio was not installed by the manufacturer, the backup activation signal may be absent from the wires connected to the car radio. For cases like this there’s a grey REVERSE wire in our cable. +12 V should be supplied to this wire when the car is switched to reverse (may be taken from the rear lamp). Also, you may check the connection of this activation signal in the diagnostics menu.
2. The additionally installed rear view camera should be powered from ACC line (first turn of the key), otherwise the camera input will be not active. Depending on the type of the camera to be connected, namely on the voltage required for the camera, you can use input voltage +6 V, which the monitor produces. In case the camera requires more than +6 V, connect the camera power to ACC line.